Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Slave E120 chartplotter crash/reboot on 3D page
04-11-19, 03:36 PM
Post: #5
RE: [CA11] Slave E120 chartplotter crash/reboot on 3D page

Thanks for the confirmation. I also just realized that I was referring to SeatalkHS (aka ethernet) by the wrong designation (SeatalkNG).

I read the reference FAQ that you provided and I can confirm that my Platinum+ chart card works just fine in all respects (including full 3D) as well as pictures, aerial overlay, etc., on the Master E120 in which has the chart card installed. The same is true on my slave E120 except for what I feel is the recent failure of the 3D page.

While I can't say with absolute certainty that viewing of the 3D chart page on the slave E120 was ever a problem in the past (I have always had the same Platinum+ chart card in the master E120) but I feel very confident that I would have tested the 3D functionality after I got the Platinum+ chart card on both chart plotters especially given that the slave E120 is at the helm of my boat. I wonder if something new may be causing the problem? Could the slave E120 benefit from a 'reset'??

That said is there a way to remove the 3D page from the slave E120 or replace it with something else?

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [CA11] Slave E120 chartplotter crash/reboot on 3D page - bobatkins - 04-11-19 03:36 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)