Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom Pro no data on NMEA2000
05-10-19, 08:46 AM
Post: #2
RE: [CA11] Axiom Pro no data on NMEA2000
Welcome to the Raymarine Forum LimaBavo,

Q. Is there a setting that I can't find to activate nmea2000 on the Axiom?
A. With the exception of configuring the MFD which has been interfaced to the NMEA 2000 backbone as the system's Data Master MFD (not necessary if the system features only one MFD), there is no setting provided within Raymarine MFDs to activate the MFD's NMEA 2000 communications interface. In systems featuring only two NMEA 2000 devices, the fault may be rooted within either one of the devices (assuming that power to the backbone has been verified. In such situations, a NMEA 2000 analyzer (ex. Actisense NGT-1 and Actisense's free NMEA Reader software, etc.) would be interfaced to the backbone in place of one of the devices to determine whether it is transmitting data to the NMEA 2000 backbone. In the case of the MFD, it should transmit if it is the system's Data Master MFD and has acquired a GPS position FIX. Alternatively, the MFD may be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom Pro no data on NMEA2000 - Chuck - Raymarine - Moderator - 05-10-19 08:46 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)