Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Installing ng Network with Existing Instruments
05-30-19, 07:08 PM (This post was last modified: 06-03-19 10:37 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Installing ng Network with Existing Instruments
Chuck,

Thanks for the quick response. The 5-way connector shown in my schematic is a converter, not a connector. To make it somewhat more clear, I added colored circles to indicate the blue, yellow and white connection ports. In the current version, I have a blanking plug in the yellow connection port on the 5-way converter because it was my understanding that the Raymarine i70s can act as a bridging device between the ST60 instruments and the ng backbone. I have shown that with a SeaTalk to Seatalk ng converter cable from the ST60 instruments to the i70s, with a spur cable going from the i70s to the 5-way converter using the white connection port. With this clarification, will the integration work as shown?

Thanks for any follow-up comments/suggested revisions.

Mark Gadson


Attached File(s)
.xlsx  Raymarine ng Wiring Schematic v2 dtd 05-30-2019.xlsx (Size: 96.61 KB / Downloads: 258)

Mark P. Gadson
Email: [email protected]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Installing ng Network with Existing Instruments - markgadson - 05-30-19 07:08 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)