Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] i60 wind giving incorrect wind data

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] i60 wind giving incorrect wind data
06-06-19, 12:40 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] i60 wind giving incorrect wind data
Welcome to the Raymarine Forum browerd,

If the transducer's leads have been directly interfaced to the instrument's transducer terminals, then the key to initiating a Factory Reset is to simultaneously press and hold the instrument's POWER and TRUE/APP buttons. After approximately 12 seconds, the instruments screen should have cycled through CAL, GRP, and then display DLR. At that point, simultaneously press and release the VMG and TACK buttons ... UC1 will be displayed. Press the DISPLAY button five times until FO is displayed. Press the TACK button one time ... F1 is displayed. Simultaneously press the press the POWER and TRUE/APP buttons and hold pressed for two seconds until you observe the instrument reset.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] i60 wind giving incorrect wind data - Chuck - Raymarine - Moderator - 06-06-19 12:40 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication