[CA] [CA11] Software Glitch - Axiom 12

[david.caron@videotron.ca]

Hello Chuck,
Connecting the Mercruiser Gateway directly to the electronics backbone was giving errors such as:
1- Conflicting Trim tabs position reading
2- Intermitent false water temp reading
3- Engine Transmission error (No transmission on my boat, only gear mode is valid...)
4- J1939 Message creating error on the Logs (Axiom & I70s)

Here is the custom filters I have loaded in the YatchD device:

# Current configuration of Yacht Devices NMEA 2000 Bridge
# Firmware: 1.31 17/07/2019
# Serial: 000xxxxx, Password level: 0
# CAN1 connected to the Mercruiser Gateway
# CAN2 connected to the Raymarine SeatalkNG Network

PGNS_TO_ASSEMBLY=
FW_CAN1_TO_CAN2=ON
FW_CAN2_TO_CAN1=OFF
CAN1_HARDWARE_FILTER_1=0x00000000,0x00000000
CAN2_HARDWARE_FILTER_1=0x00000000,0x00000000
CAN2_SPEED=250

match(CAN1, 0x01FE1000, 0x01FFFF00)
{
# Block message about TrimTab from CAN1
}

match(CAN1,0xEF,0xFF)
{
# Block message for Engine with EF in J1939
}

match(CAN1,00,0xFF)
{
# Block message for Engine with 00 in J1939
}

match(CAN1,01,0xFF)
{
# Block message for Engine with 01 in J1939
}

match(CAN1, 0x1F20500, 0x1FFFF00)
{
a=get(DATA,UINT8)
if (a < 0x11) {
send(CAN2)
}
# Block message with transmission data except gear mode
}

match(CAN1, 0x01FD0600, 0x01FFFF00)
{
a=get((DATA + 1),UINT32)
if (a > 0xffff5d07) {
send(CAN2)
}
# Block Negative temperature (Bad reading) on Water Temp
}

Let me know if additionnal info is required.
Kind Regards,
David