Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Some info not displayed by pilot controller
08-21-19, 03:13 PM
Post: #2
RE: [CA11] Some info not displayed by pilot controller
Welcome to the Raymarine Forum Jeff,

The problem reported may in fact be due to the limited data bridging of the early SPX autopilot software. It would accordingly be recommended that you verify that:
- the MFD and SPX autopilots have each been interfaced to one another via a powered and properly terminated SeaTalkng / NMEA 2000 backbone.

- the MFD's software has been updated to LightHouse II v19.03 ... and if not update accordingly

- the SPX autopilot's software has been updated to v3.05 ... and if not update accordingly via the MFD

- the system should feature a SeaTalk to SeaTalkng Converter and its software has been updated to v2.03 ... and if not update accordingly via the MFD

- the ST7001 should be disconnected from the SPX autopilot's SeaTalk port

- the ST7001 and ST60 Instruments should be daisy chained to one another, and then to the SeaTalk socket of the SeaTalk to SeaTalkng Converter.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Some info not displayed by pilot controller - Chuck - Raymarine - Moderator - 08-21-19 03:13 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)