Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Axiom units chane from ft/miles to m/km
08-26-19, 01:10 AM (This post was last modified: 09-09-19 01:27 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [TG11] Axiom units chane from ft/miles to m/km
Hello E.hatch2086,

Can you tell me what devices are in your system?
I've never seen this happen as a result of an internal software error on an MFD, but I suspect that it may be able to happen if you have a Seatalk1-SeatalkNG Convertor (part E22158) in your system, and you have a level of corruption of the data on your legacy Seatalk1 network. Do you have one of these convertors in your system, and if you do, does the problem go away if you temporarily disconnect it from the Seatalk1 network?

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 08-26-19 01:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)