[CA] [CA11] LH 3 Navionics Plotter Sync

[nharrison5]

Thanks Chuck. After further conversation, I confirmed the following.

1) I updated the eS127 MFD to the September 27, 2019 release, then confirmed that it updated properly, and is the version the MFD is operating with.
2) My Navionics card expires 08-02-2020 and is the US-Canada version. I confirmed that on the MFD.
3) my Navionics app on the IPad is the October 4th, 2019 release which Navionics asked me to ensure was on my IPad and my IPhone.
4) I have attached a copy of the error message that I was having on my IPad when I attempted to sync routes.
5) I tried updating using the Navionics card in one slot with nothing on the other. I then switched the Navionics card to the other slot. Neither worked.
6) I attempted to sync with the Navionics card in one slot and a 16gb card I have used before in the other slot.
7) I switched the cards and tried again.

Prior to trying the above and after updating to the LH 3 September 27 version, I shut the chart plotter and IPad down. I then rebooted both. I also tried the update with my IPhone. None of the above worked and I am still getting the same error message which is attached below.

I did import the routes using gpx files that I manually downloaded to a card, and they are now on my plotter. However, I am limited now to the manual process until this issue between the two softwares is resolved. I will also communicate this info to Navionics.