Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] CP370 Transducers
11-13-19, 01:46 PM (This post was last modified: 11-13-19 02:50 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] CP370 Transducers
The Raymarine specs for the CP370 fishfinder say that it will reach a depth of 5000' but the specs for available transducers are vastly different. The B164 1KW transducer at 50khz say that it is good for 1200' to 1800'. The specs for the B260 1KW transducer at 50khz say 1800' to 2500'. What transducer could I use to get the 5000' range of the CP370? I fish Hudson Canyon and often run into depths approaching 5000' and I don't want to drill a [censored] in the bottom if I can't get at least 4000'. Also, the M260 1KW in-hull transducer at 50khz is rated at 1800' to 2500'. How good would this transducer be in terms of clear readings and what would the actual depth maximum really be? Are there any restrictions as to the thickness of the hull? Thank You.
Find all posts by this user
Quote this message in a reply
11-13-19, 03:09 PM
Post: #2
RE: [CA11] CP370 Transducers
Welcome to the Raymarine Forum Donald,

If using a CP370, the E66075 2kW R99 thru hull transducer (will only be driven at 1kW by a CP370) would typically be recommended for this application. That said, 2kW power would be recommended for reliably sounding these depths. For MFDs compatible with such, a CP570 Professional CHIRPâ„¢ Sonar Module and compatible a 2kW or 3kW through hull CHIRP transducer (ex. R109 LH or R509 LH) would typically be recommended for those fishing in 4000' to 5000' depths.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)