Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Connect Raystar 125 to E95 NMEA 0183
03-05-20, 04:05 PM (This post was last modified: 03-05-20 04:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Connect Raystar 125 to E95 NMEA 0183
Hi,

I want to connect the Raystar125 to the NMEA0183. The manual is not clear as it does not show a possibility of the GPS with only NMEA OUT + and the plotter with NMEA IN + and -.
I understand I need 12V and ground/0 for the antenna and connect the 2 not used wires to ground. But what do I connect to the IN - on the plotter?
Find all posts by this user
Quote this message in a reply
03-05-20, 04:52 PM (This post was last modified: 03-05-20 04:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Connect Raystar 125 to E95 NMEA 0183
Welcome to the Raymarine Forum

Please see the chart below addressing how to interface a Raystar 125 GPS Sensor to c/e-Series MFD.

[Image: attachment.php?aid=4196]


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
03-06-20, 04:02 AM (This post was last modified: 03-06-20 10:54 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Connect Raystar 125 to E95 NMEA 0183
So as I understand correctly, output from E95 connected to input from Raystar 125 and output Raystar 125 connected to input E95. Sounds logic but differs from earlier NMEA013 where you use NMEA IN the + and the -. Am I right?

In connect the brown and black from the Raystar 125 to GND 0V. DO I also have to do that with green and brown from the E95 or can I leave them disconnected?
Find all posts by this user
Quote this message in a reply
03-06-20, 10:56 AM
Post: #4
RE: [CA11] Connect Raystar 125 to E95 NMEA 0183
Marien,

Q1. As I understand correctly, output from E95 connected to input from Raystar 125 and output Raystar 125 connected to input E95.
A1. Correct.

Q2. In connecting the brown and black from the Raystar 125 to GND 0V. DO I also have to do that with green and brown from the E95?
A2. Yes.
Find all posts by this user
Quote this message in a reply
03-07-20, 12:52 PM (This post was last modified: 03-09-20 09:07 AM by Chuck - Raymarine - Moderator.)
Post: #5
RE: [CA11] Connect Raystar 125 to E95 NMEA 0183
It works. Thanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)