Wind transducer
|
06-14-17, 03:50 PM
Post: #2
|
|||
|
|||
RE: Wind transducer
Welcome to the Raymarine Forum Joe,
It is recommended that the wind pod be disconnected from the spur socket connecting it to the backbone and that it then be reconnected. It is recommended that all transducer connections to the pod be disconnected and then reconnect to ensure good contact. Finally, it is then recommended that all power and ground connections to the SeaTalkng backbone be inspected from the SeaTalkng Power Cable or autopilot course computer through any circuit panels to the batteries to ensure that all connections are tight and free of corrosion. Should the problem manifest itself thereafter, then it would be recommended that the pod be sent to Raymarine’s Product Repair Center to be bench checked / serviced. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Wind transducer - jhaas - 06-14-17, 12:07 PM
RE: Wind transducer - Chuck - Raymarine - Moderator - 06-14-17 03:50 PM
|
User(s) browsing this thread: 1 Guest(s)