Raymarine forum / Raymarine Forums / Fishfinders v / [CA] [CA11] Axiom sounder voltage supply too low? My battery has 12.40 volts?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom sounder voltage supply too low? My battery has 12.40 volts?
01-02-19, 11:14 AM (This post was last modified: 01-02-19 12:04 PM by Chuck - Raymarine - Moderator.)
Post: #4
ray18 Offline
Member
***
 		Posts: 91
Joined: Feb 2017
Reputation: 0
RE: [CA11] Axiom sounder voltage supply too low? My battery has 12.40 volts?
I switched my 7amh battery for my kayak to the 35 amh for my big boat electronics when I went out again to test the Raymarine UAV on my Axiom 9" MFD mounted on my kayak.

I had no more warnings of low voltage when flying my drone and using 3D fishfinder. The bigger battery is needed if you plan to be on the water longer than 2 hours to use 3d fishfinder and flying the drone.

7amh can only last for 2 hours doing both, and then it will not power 3d fishfinder or connected to the drone and flying the drone.
http://www.youtube.com/njfishing1 - from Captain Steve
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom sounder voltage supply too low? My battery has 12.40 volts? - ray18 - 01-02-19 11:14 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication