Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help with my A57D
07-22-16, 03:58 PM
Post: #1
Help with my A57D
I have an A57D model that I recently obtained from an estate sale but did not come with a power cable. I am trying to rig it just to test for power, but do not know the correct configuration of the pos. and neg. pins. The photo I have attached here shows the PWR/NMEA port with 11 pins (2 in the middle I assume are +/-). Can anyone tell me which is which so I can rig to a battery? Also would reversing them fry the components inside? I am trying to avoid this at all costs.

Please respond assap - thank you in advance.

PS: The owner's manual does not show this
Find all posts by this user
Quote this message in a reply
07-25-16, 03:31 PM
Post: #2
RE: Help with my A57D
Welcome to the Raymarine Forum Bluegill11,

The large lower male pin should be interfaced +12VDC while the large upper male pin should be interfaced -12VDC.
Find all posts by this user
Quote this message in a reply
07-28-16, 05:17 AM (This post was last modified: 07-28-16 07:49 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: Help with my A57D
Chuck, thank you very much for your reply.. this helps me out a lot. I was not brave enough to just take the 50/50 chance, and couldn't find any schematics on this model online at all.

If I had the 2 pins connected in reverse, would I have caused any internal damage to the unit, or is there perhaps a fuse inside that would have protected it against reverse polarity? Also do you own this model yourself?

Thank you again!
Regards
Find all posts by this user
Quote this message in a reply
07-28-16, 07:58 AM
Post: #4
RE: Help with my A57D
Bluegill11,

You're welcome. The A-Series Classic MFDs should be protected against reverse polarity.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)