Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Converting from old Analog Radar
10-24-17, 12:10 PM
Post: #1
Wink Converting from old Analog Radar
I just upgraded my MFD from a C80 to a C95. Of course, now I need to upgrade the analog radar.

I would like to purchase a new Raymarine Quantumâ„¢ Wireless CHIRP Radar with the ethernet port.

My question is can I purchase an adapter cable to utilize the existing power that is on the old cable. I would rather that than ave to snake a new cable through the mast.

I don't plan on using the ethernet port but figure if the wifi becomes problematic O have a way out

Thanks
Find all posts by this user
Quote this message in a reply
10-24-17, 02:23 PM
Post: #2
RE: Converting from old Analog Radar
Welcome to the Raymarine Forum 845cpl,

While it may be possible to splice the currently installed analog radar cable to the Quantum radome's power cable to supply power to the Quantum radome, wired data communications cannot be supported by the currently installed cable. Accordingly, if seeking a wired data interface with the Quantum radome, then it will be necessary to install a Quantum Data Cable.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us