Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] Axiom 3d tansducer pair
02-03-18, 09:01 AM (This post was last modified: 02-05-18 11:33 AM by Chuck - Raymarine - Moderator.)
Post: #1
[DG] Axiom 3d tansducer pair
Hi All,

I have a Botnia Targa 27.1 and have the twin 3D bronze with 20 degrees compensation as my hull is 19 degrees at midships. I have read the fitting instructions and it states to fit them parallel as close as possible to the hull centreline. They will be about 12 inches roughly apart or do I fit them closer as I could probably get them 6 inches apart obviously parallel ?

Kk
Find all posts by this user
Quote this message in a reply
02-09-18, 10:01 AM
Post: #2
RE: [DG] Axiom 3d tansducer pair
Hi SIESTA BOTNIA
Thank you for your enquiry,

mounting the transducers 12" will be fine, in practice up to 36" apart is OK, just make sure they are parallel and equi-spaced from the keel.

Regards
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us