Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] How do you program COG Line on Axiom?
06-16-18, 03:16 PM (This post was last modified: 06-18-18 03:13 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] How do you program COG Line on Axiom?
My friend has a new Axiom plotter, and I can't find where to program the COG line. Can you help please?
Find all posts by this user
Quote this message in a reply
06-18-18, 03:26 PM
Post: #2
RE: [CA11] How do you program COG Line on Axiom?
Welcome to the Raymarine Forum Doug,

As vectors are associated the vessel icon, holding one's finger pressed atop the vessel icon within the Chart application will cause a vessel icon context menu to be displayed. From this context menu, the operator may select to display the COG (vessel must be moving) and/or Heading (system must be interfaced to a heading source) vectors as well as to configure the length of these vectors.
Visit this user's website Find all posts by this user
Quote this message in a reply
06-19-18, 09:24 AM
Post: #3
RE: [CA11] How do you program COG Line on Axiom?
Chuck, THANKYOU.

Where, or in what manual, would point this out?

Can you provide a link?
Visit this user's website Find all posts by this user
Quote this message in a reply
06-19-18, 09:54 AM
Post: #4
RE: [CA11] How do you program COG Line on Axiom?
Oregoncme,

This may be found within the Vessel Details section Chapter 8.1 Chart app overview (more specifically page 96) of the LightHouse 3.4 Advanced Operation Instructions.
Visit this user's website Find all posts by this user
Quote this message in a reply
06-19-18, 02:43 PM (This post was last modified: 06-19-18 03:54 PM by Chuck - Raymarine - Moderator.)
Post: #5
RE: [CA11] How do you program COG Line on Axiom?
You are right on the money Chuck!
Thank you very much!
Find all posts by this user
Quote this message in a reply
06-19-18, 03:55 PM
Post: #6
RE: [CA11] How do you program COG Line on Axiom?
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us