Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] RL80CRC C-Map NT+ International boundary
08-09-19, 07:50 AM (This post was last modified: 08-20-19 03:24 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] RL80CRC C-Map NT+ International boundary
Hello, I have a 2004 Raymarine RL80CRC with a C-map NT+ chart of Lake St Clair and Lake Erie.
The U.S/Canadian border runs right through the middle of Lake St Clair, however, it does not appear on my chart. I contacted C-Map yesterday and they see the border on their chart.
Does anyone know what I would have to toggle on or off to be able to see this border?
Thanks
Find all posts by this user
Quote this message in a reply
08-20-19, 03:36 PM
Post: #2
RE: [CA11] RL80CRC C-Map NT+ International boundary
Welcome to the Raymarine Forum Downrod,

While it may be possible that the C-Map cartography may include the international boundary, it is also possible that the display's software may not support displaying the boundary object. Unfortunately, support for these legacy displays is now quite limited and we do not have any C-Map NT+ cartography of the Great Lakes or boundary area. It is recommended that you verify that the following display settings have been configured:
Chart Display: Detailed
Nav Marks: On
Caution and Routing Data: On ... this is the most likely configuration setting responsible for the boundary and it may only be visible at certain chart ranges.
Marine Features: On
Land Features: On
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us