[TG] [TG11] eS127 re-boot using LH 3
|
11-16-19, 10:20 AM
(This post was last modified: 11-18-19 10:03 AM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: [TG11] eS127 re-boot using LH 3
Tom,
Thanks for the answer. It is an eS127 running LH 3, not an Axiom. I factory reset the eS127 MFD prior to seeing this. Just after resetting, in the same session, the MFD crashed again. After the MFD rebooted, I re-installed the routes I had installed using the plotter sync feature of Navionics. I noticed the route names are all truncated so that the route name doesn’t fully describe the route on the MFD. This is not the case on the Navionics app. Is this a bug? That doesn’t happen when I use a MicroSD card. I will copy the log that currently exists and send in, but it did not happen while under way. It happened right after the factory reset. Nate |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] eS127 re-boot using LH 3 - nharrison5 - 10-30-19, 06:13 PM
RE: [TG11] eS127 re-boot using LH 3 - Tom - Raymarine - Moderator - 11-07-19, 12:36 AM
RE: [TG11] eS127 re-boot using LH 3 - nharrison5 - 11-16-19 10:20 AM
RE: [TG11] eS127 re-boot using LH 3 - Tom - Raymarine - Moderator - 11-19-19, 11:37 PM
RE: [TG11] eS127 re-boot using LH 3 - nharrison5 - 11-23-19, 09:39 PM
RE: [TG11] eS127 re-boot using LH 3 - Tom - Raymarine - Moderator - 11-26-19, 08:53 PM
RE: [TG11] eS127 re-boot using LH 3 - nharrison5 - 11-26-19, 09:16 PM
RE: [TG11] eS127 re-boot using LH 3 - nharrison5 - 12-10-19, 12:37 AM
RE: [TG11] eS127 re-boot using LH 3 - Zonefive1 - 12-07-19, 11:58 PM
RE: [TG11] eS127 re-boot using LH 3 - Tom - Raymarine - Moderator - 12-09-19, 09:11 PM
RE: [TG11] eS127 re-boot using LH 3 - Tom - Raymarine - Moderator - 12-16-19, 11:02 PM
RE: [TG11] eS127 re-boot using LH 3 - nharrison5 - 12-17-19, 11:12 AM
|
User(s) browsing this thread: 1 Guest(s)