Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] e7 MFD Screen Malfunction

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] e7 MFD Screen Malfunction
04-30-18, 10:54 AM (This post was last modified: 04-30-18 03:59 PM by Chuck - Raymarine - Moderator.)
Post: #1
cptdoug1 Offline
Junior Member
**
 		Posts: 2
Joined: Mar 2016
Reputation: 0
[CA] e7 MFD Screen Malfunction
My e7 MFD's screen has turned green and has vertical lines on it. This happened as I sailed to Guatemala where I am now. Are there any known fixes for this?
Find all posts by this user
Quote this message in a reply
05-01-18, 09:42 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] e7 MFD Screen Malfunction
Welcome to the Raymarine Forum Doug,

It is recommended that the loaded system voltage be measured at the display's power plug. Should the measured voltage be within the operating range of the MFD (10.8V dc to 31.2V dc) and the MFD's screen have the specified appearance after being switched ON, then it would be recommended that the MFD be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication