[CA] [CA11] GS125, VHF RAY260 AIS not working

[eddiejaimes]

good Morning ,

I have a GS125, I recently upgraded the software to the latest LH3 I have a RAY260 VHF radio conected to the network via sea talk. I cant see any of the targets on the chart plotter, Is there anything that i should be looking? I looked in the menu of the vhf and make sure the unit is conected via nma200

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Eddie,

Per our phone conversation, it recommended that you ensure that Ray260's AIS feature has been enabled:

Switching the AIS function on and off
The AIS function on the Ray260 AIS and Ray260E AIS can be switched on or off.
From the main menu:
1. Select CONNECTION.
2. Select AIS.
3. Select ON or OFF as required.

Additionally, with the built-in AIS receiver switched on AIS information can be sent to a connected Raymarine multifunction display using either the NMEA 0183 or SeaTalkng connections.

Note: If using the built-in AIS receiver and outputting over NMEA 0183, ensure that the baud rate is set to high speed: Menu > Connection > Interface > NMEA 0183 > HIGH