Raymarine forum / Raymarine Forums / Multifunction Displays v / Raymarine upgrade

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raymarine upgrade
11-29-16, 06:16 PM (This post was last modified: 11-30-16 09:02 AM by Chuck - Raymarine - Moderator.)
Post: #1
Seamonkeys Offline
Junior Member
**
 		Posts: 2
Joined: Nov 2016
Reputation: 0
Raymarine upgrade
Upgrading electronics and have chosen Raymarine a97 with Digital HD Radar dome. Rep at Raymarine said I can use the same transducer by disconnecting the cable to the grey box and bypassing with a adapter cable. This is where I'm stuck. Which adapter Cable?
Find all posts by this user
Quote this message in a reply
11-30-16, 09:02 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Raymarine upgrade
Welcome to the Raymarine Forum Seamonkeys,

Should the currently installed fishfinder transducer be interfaced to a CP370, CP300, DSM300, DSM30, or DSM250 fishfinder sounder module, then the transducer may simply be unplugged from the fishfinder sounder module's TRANSDUCER socket, an E66066 Transducer Adapter would then be connected to the transducer's plug, and finally, the other end of the E66066 Transducer Adapter would be connected to the MFD's TRANSDUCER socket. This solution is applicable to any ax7, cx7, e7D, ex7, or eSx7 MFD.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication