Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Is System Diagram Correct - no power to i 70 and p 70

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Is System Diagram Correct - no power to i 70 and p 70
06-13-18, 01:35 PM (This post was last modified: 06-13-18 02:00 PM by Chuck - Raymarine - Moderator.)
Post: #1
judyfusco Offline
Junior Member
**
 		Posts: 1
Joined: May 2018
Reputation: 0
[CA11] Is System Diagram Correct - no power to i 70 and p 70
We installed an autopilot, an axiom 7 MFD and wind/depth instruments using the attached system diagram. When we powered it up, the computer had power as did the MFD. However, the i 70 and p70 instruments would not turn on. Is there something incorrect in the system diagram or should I double check all connections?


Attached File(s)
.pdf  raymarine wiring.pdf (Size: 886.38 KB / Downloads: 377)
Find all posts by this user
Quote this message in a reply
06-13-18, 02:07 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Is System Diagram Correct - no power to i 70 and p 70
Welcome to the Raymarine Forum Judy,

I can find no fault with your diagram. However, it appears that your SeaTalkng backbone is not receiving power. I would recommend starting with the SeaTalkng Power Cable.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication