Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] Connectors

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Connectors
07-04-18, 02:11 PM (This post was last modified: 07-06-18 12:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
Polaris Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2018
Reputation: 0
Question [CA11] Connectors
What advice can you give converting flat electrical connectors to 5 pin DIN connectors for Remote ST60 wind, speed, depth, and auto helm instruments located with a slave C80 Mfd in the cockpit with a C90W at the inside helm of a PacificSeacraft motor sailor?
Find all posts by this user
Quote this message in a reply
07-06-18, 12:35 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Connectors
Welcome to the Raymarine Forum Polaris,

Generally speaking, Raymarine recommends use of its networking components for maximum system performance within a marine environment. Any third party cables and connectors chosen should be designed for use within the marine environment. Gemeco, Inc. (Airmar’s US distributor (803 693 0777)), carries a number of such networking components.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication