[CA] [CA11] GS125, VHF RAY260 AIS not working
|
06-27-19, 09:50 AM
(This post was last modified: 07-02-19 10:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] GS125, VHF RAY260 AIS not working
good Morning ,
I have a GS125, I recently upgraded the software to the latest LH3 I have a RAY260 VHF radio conected to the network via sea talk. I cant see any of the targets on the chart plotter, Is there anything that i should be looking? I looked in the menu of the vhf and make sure the unit is conected via nma200 |
|||
07-02-19, 11:05 AM
Post: #2
|
|||
|
|||
RE: [CA11] GS125, VHF RAY260 AIS not working
Welcome to the Raymarine Forum Eddie,
Per our phone conversation, it recommended that you ensure that Ray260's AIS feature has been enabled: Switching the AIS function on and off The AIS function on the Ray260 AIS and Ray260E AIS can be switched on or off. From the main menu: 1. Select CONNECTION. 2. Select AIS. 3. Select ON or OFF as required. Additionally, with the built-in AIS receiver switched on AIS information can be sent to a connected Raymarine multifunction display using either the NMEA 0183 or SeaTalkng connections. Note: If using the built-in AIS receiver and outputting over NMEA 0183, ensure that the baud rate is set to high speed: Menu > Connection > Interface > NMEA 0183 > HIGH |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)