Raymarine forum / Raymarine Forums / Instruments v / ST50 VMG Wind Repeater

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST50 VMG Wind Repeater
06-20-16, 01:02 PM
Post: #1
jefndeb Offline
Mainship 400
***
 		Posts: 54
Joined: Feb 2016
Reputation: 0
ST50 VMG Wind Repeater
Hello,

When a ST50 VMG wind display is pigail connected to a fully functional ST50 Wind display/system, (including a functional masthead), I read that if there is SOW on the seatalk bus (which there was not) it will repeat wind speed, (seatalk bus communication verified via lamp brightness settings) but will the wind direction pointer not function either without SOW? Just wondering because it doesn't repeat wind speed or mimicked the pointer...
Find all posts by this user
Quote this message in a reply
06-20-16, 03:23 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ST50 VMG Wind Repeater
Welcome to the Raymarine Forum jefndeb,

Please note that ST50 Instruments are no longer supported. As such knowledge of this product family is starting to get a bit thin. According to our service team, your ST50 VMG is functioning consistently with their recollection of its design ... i.e. it should not be expected to repeat wind data in a system lacking speed through water.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication