Raymarine forum / Raymarine Forums / Instruments v / which O ring do I use

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
which O ring do I use
06-09-16, 01:05 PM
Post: #1
LeslieTroyer Offline
Junior Member
**
 		Posts: 9
Joined: Jun 2016
Reputation: 0
which O ring do I use
I have a DST800 - I want to put the sensor into an existing airmar housing. I've made sure the sensors are the same length.

The differences between the two are the lack of a gate and a notch at the top of the old housing. Do I use the thick O-ring with this housing --

I'll change to the supplied fitting when I next pull the boat.

Les
Find all posts by this user
Quote this message in a reply
06-09-16, 01:43 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: which O ring do I use
Welcome to the Raymarine Forum Les,

It is recommended that Gemeco's (Airmar's US distributor) support team be consulted on this subject.
Find all posts by this user
Quote this message in a reply
06-17-16, 01:51 PM (This post was last modified: 06-20-16 09:24 AM by Chuck - Raymarine - Moderator.)
Post: #3
LeslieTroyer Offline
Junior Member
**
 		Posts: 9
Joined: Jun 2016
Reputation: 0
RE: which O ring do I use
I got [email protected] from their web site.

Les
Find all posts by this user
Quote this message in a reply
06-20-16, 09:25 AM
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: which O ring do I use
Noted.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication