Raymarine forum / Raymarine Forums / Autopilots v / [DG] [DG] smartpilot s3

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] smartpilot s3
01-22-19, 10:46 AM (This post was last modified: 01-22-19 12:26 PM by Derek - Raymarine - Moderator.)
Post: #31
ricardomann Offline
Junior Member
**
 		Posts: 23
Joined: Oct 2018
Reputation: 0
RE: [DG] smartpilot s3
Hi Derek . That will do the job .
I got the ST6001 control head used . Should i do a factory reset on it
first? then do all the commissioning ?
if yes how do i do the reset . cannot se it in the manual
thanks
ricardo
Find all posts by this user
Quote this message in a reply
01-22-19, 12:27 PM
Post: #32
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG] smartpilot s3
Hi Ricardomann,

No need to carry out a reset on the control unit, all the calibration is stored in the Course computer.
Thanks
Derek
Find all posts by this user
Quote this message in a reply
01-22-19, 02:21 PM (This post was last modified: 01-22-19 05:23 PM by Chuck - Raymarine - Moderator.)
Post: #33
ricardomann Offline
Junior Member
**
 		Posts: 23
Joined: Oct 2018
Reputation: 0
RE: [DG] smartpilot s3
got it
Thanks Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication