European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
Raymarine forum
/
Raymarine Forums
/
Multifunction Displays 
/
[CA] [CA11] Axiom 12 and Axiom 9 not communicating
/
[CA] [CA11] Axiom 12 and Axiom 9 not communicating
|
[CA] [CA11] Axiom 12 and Axiom 9 not communicating
|
|
08-20-19, 01:54 PM
(This post was last modified: 08-23-19 02:26 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
|
[CA11] Axiom 12 and Axiom 9 not communicating
I have an Axiom 12 Pro and Axiom 9 (display only). Before the last update (week ago) on both units, all was fine. The 12 was set up as the data master prior to update. Now the 9 does not acknowledge the 12 and shows itself as the date master. Also, new waypoints installed did not save to the unit and had to be re-inputted three days in a row. The 12 also got stuck in power up mode a couple of times at start up.
|
|||
|
|
08-23-19, 02:34 PM
Post: #2
|
|||
|
|||
|
RE: [CA11] Axiom 12 and Axiom 9 not communicating
Welcome to the Raymarine Forum RV,
It is recommended that you verify that each MFD has been updated with LightHouse 3 v3.10.42 or later software. If so, then it is recommended that a Power On Factory Reset operation be performed to each MFD to address the reported issue. It is further recommended that the MFD's settings be manually reconfigured rather then restored from a saved system settings file. Restoring waypoint/route/track data may be done without concern. |
|||
|
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)