Raymarine forum / Raymarine Forums / Networking / System Integration v / [TG] [TG11] E 120 Classic to Axiom7

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] E 120 Classic to Axiom7
05-30-20, 01:15 AM (This post was last modified: 06-09-20 11:35 PM by Tom - Raymarine - Moderator.)
Post: #1
Thefin25 Offline
Junior Member
**
 		Posts: 2
Joined: May 2020
Reputation: 0
[TG11] E 120 Classic to Axiom7
Can I interface E120 MFD and its charts , platinum +, with Axiom 7? If so how is it done.
I Don't see a difference in the detail charts and the fishing charts on the Axiom. Is a different chart card needed?
Find all posts by this user
Quote this message in a reply
06-09-20, 11:37 PM
Post: #2
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: [TG11] E 120 Classic to Axiom7
Hello Thefin25,

No, I'm sorry to say that's not possible, the general rule is that only displays that are running the same software can be networked over SeatalkHS / Raynet / Ethernet to share radar, chart, sonar etc.. You will need a separate chart card for each.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication