Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ECI-100 Reset
12-05-16, 11:53 AM
Post: #1
ECI-100 Reset
Hi -

I've changed the drive system of my sailboat and my ECI-100 is giving me fault codes not in the fault code list (STNG solid green, DeviceNet cycles 7 red blinks followed by solid red).

The manual says:

"Your ECI-100 will need resetting if it has previously been used on a different engine type."

and

"A specialist tool is required to reset the ECI-100, contact Raymarine Product Support for further information."

So, how do I go about getting it reset?
Find all posts by this user
Quote this message in a reply
12-05-16, 05:10 PM
Post: #2
RE: ECI-100 Reset
Welcome to the Raymarine Forum liquidether,

It is recommended that ECI-100s which need to be reset be sent to Raymarine’s Product Repair Center.
Find all posts by this user
Quote this message in a reply
12-08-16, 01:18 PM
Post: #3
RE: ECI-100 Reset
It seems I have a problem beyond resetting the ECI-100. My new drive system apparently speaks CANopen and not J1939. Are there any plans to add CANopen mappings to the ECI-100 or your LightHouse software? Thanks.
Find all posts by this user
Quote this message in a reply
12-12-16, 10:52 AM
Post: #4
RE: ECI-100 Reset
liquidether,

What make/model of engine system are you attempting to use in conjunction with the ECI-100?
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)