Threaded Mode | Linear Mode

Northman

I bought a ST60 Wind with my boat.
It shows not the winddirection. It goes from left to right and back the whole time. Without the mastunit it spinns around. I think the Pointer should go up to 12 and stand there. Could it be that the pointerunit must be calebrated?
Thanks for answer.
Sven

***Derek - Raymarine - Moderator*** · 02-13-19, 07:19 AM

Hi Northman

Thankyou for your enquiry.

YOu are quite right, with no masthead Tx connected, ( disconnect the cable from the back of the display to eliminate any problems due to a damaged cable), when the power is cycled off and back on, the pointer of the wind display should move to the 12 o'clock position.

Check it is receiving a smooth 12v supply and if the fault persists, then it is likely the wind display is faulty and should be returned to an approved Raymarine repair centre or service dealer.

regards
Derek