G SERIES WAS UPDATED BUT CHANGED DISPLAY LAYOU APPEARANCE

[Chuck - Raymarine - Moderator]

Dave,

Q: ok, to do so (since the other gp400 unit has no cf card in the back) do I just go thru step to remove care from the "updated unit" and then insall and reboot into the other unit?
A: After removing the CF memory card or USB thumb drive containing the G-Series GPM400 software update from the GPM400 which is presently running v4.66 software, then the other GPM400 will be powered OFF, the CF memory card or USB thumb drive will then be inserted into the corresponding slot of the GPM400 to be updated, and then the GPM400 to be updated will be switched ON.

This thread has now strayed from its original topic. Should you need to discuss anything further which is not directly associated with the original topic, then please create a new thread(s) to discuss the new subject(s).