[CA] Axiom transducer selection

[RayJoe46]

I would like to purchase a down vision or real vision transducer for my Axiom MFD.
I would like a thru hull transducer and if possible the dimension of the shaft of the new transducers that will work with the Axiom. My Axiom is an Axiom 9 with real vision.
My boat is a 1983 Tiara 31 open.

Thanks,
Joe
[email protected]

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Joe,

The hull's deadrise in the location where the transducer will be installed will need to be measured. A RV-212 transducer pair would be recommended for deadrise angles from 1° to 12°. The RV-220 transducer pair would be recommended for deadrise angles from 13° to 20°. Full dimensional data for these transducers may be found within Chapter 3.7 - Transducer dimensions - RV-2xx of the RV-2xx 3D Bronze Transducer Installation Instructions.