Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] What is inside the hump on the back of the a78?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] What is inside the hump on the back of the a78?
06-18-18, 05:04 PM (This post was last modified: 06-20-18 03:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
BruceW Offline
Junior Member
**
 		Posts: 8
Joined: Jun 2017
Reputation: 0
[CA11] What is inside the hump on the back of the a78?
Is that empty space? Is anything important in there or is it just for looks?

Let say someone wanted to install a ram mount on the back of the unit. Would it be safe to put screws into that plastic hump? Obviously those screws would be sealed to prevent water intrusion.
Find all posts by this user
Quote this message in a reply
06-20-18, 03:51 PM (This post was last modified: 06-20-18 03:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] What is inside the hump on the back of the a78?
Welcome to the Raymarine Forum Bruce,

The hump which you have referenced houses a circuit board with a transformer and a few large capacitors. That said, such breaches to a product's case would quite possibly void the product's warranty. Ram offers mounts having flat bases to accommodate the MFD's trunion bracket. Additionally, the pod / mounting surface in which the MFD will be installed must have sufficient clearances to satisfy the requirements specified within the a-Series Product Dimensions section of Chapter 3.13 Selecting a location of the a/c/e-Series MFD Installation Instructions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication