European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
|
[DG] [DG11] Smart Pilot LTP13
|
|
03-03-19, 12:30 PM
(This post was last modified: 03-04-19 12:08 PM by Derek - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
|
[DG11] Smart Pilot LTP13
From the Smart Pilot Service Manual:
"Rate gyro 1. Using a DVM, measure the voltage at the rate gyro output (LTP13). If the rate gyro is serviceable, the nominal reading is 2.5 V ± 0.3 V." Where is LTP13? |
|||
|
|
03-04-19, 12:09 PM
(This post was last modified: 03-04-19 12:16 PM by Derek - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
|
RE: [DG11] Smart Pilot LTP13
Hi mcarroll51
The test point is located withinn the SPX course computer and is shown below regards Derek |
|||
|
|
|
03-04-19, 04:14 PM
(This post was last modified: 03-04-19 04:31 PM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
|
RE: [DG11] Smart Pilot LTP13
Thanks. Can you direct me to it on the circuit board?
|
|||
|
|
|
03-05-19, 04:56 AM
Post: #4
|
|||
|
|||
|
RE: [DG11] Smart Pilot LTP13
Hi mcarroll51
Troubleshooting/diagnostic/repair information which extends to opening a product's case to perform any specific testing or repairs to the product's circuitry is outside of the scope which is to be supported via Raymarine's Forum. We are unable to give further details on the forum since this level of repair is supported only through the Raymarine approved dealer network. Regards Derek |
|||
|
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)