Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Is it possible to link axiom 9 ff with dv220 and b175
02-14-20, 04:56 PM (This post was last modified: 02-18-20 10:10 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Is it possible to link axiom 9 ff with dv220 and b175
Hi, Hames here. Thanks for your advice. I have to throughhull dv220 transducers installed on my boat; because of limited positioning on bottom of boat a little to much disturbance doesn't allow for good bottom readings at speed.

Therefor i was thinking of installing a b175m transducer with 470 transducer module to improve preformance and depth range.

Was wondering with this setup if i could have both the 220 for side an down imaging run the same time as the b175?
Find all posts by this user
Quote this message in a reply
02-18-20, 10:16 AM
Post: #2
RE: [CA11] Is it possible to link axiom 9 ff with dv220 and b175
Welcome to the Raymarine Forum JammanJ,

Q. Was wondering with this setup if i could have both the 220 for side an down imaging run the same time as the b175?
A. Yes. As DownVision and SideVision transducer elements chirp across a 60kHz range centered on 350kHz and the B175M chirps across a 60kHz range centered on 100kHz, they should be able to operate without interfering with one another.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)