Raymarine forum / Raymarine Forums / Multifunction Displays v / Power Control

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Power Control
05-11-20, 08:42 AM
Post: #1
svalvasori Offline
Junior Member
**
 		Posts: 9
Joined: Mar 2018
Reputation: 0
Power Control
I have an e127 and a smaller Axiom MFD. The e127 is the master and they are running LH3. Is it possible to have the power of the slave MFD turn on and off with the master? I feel like it should be able, but have not found the option to enable it.
Find all posts by this user
Quote this message in a reply
05-13-20, 02:58 PM
Post: #2
Chris - Raymarine - Moderator Offline
Senior Member
****
 		Posts: 266
Joined: May 2016
Reputation: 0
RE: Power Control
Hello svalvasori,

These displays do not have the option you are describing. They will need to be turned off individually unless they could be powered from the same circuit breaker.

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication