[TG] [TG11] Integrating new components with older ones
|
06-01-20, 10:32 AM
(This post was last modified: 06-10-20 12:24 AM by Tom - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[TG11] Integrating new components with older ones
I just purchased a 2000 Sea Ray 410 Sundancer with a full compliment of Raymarine electronics including Radar, GPS and AutoPilot. All of the systems are original to the boat and the chartplotter currently will not get a fix. I would like to upgrade the GPS/Chartplotter to a new Axiom 9 or 12 but wondering if any of the other systems will still be compatible/usable? Does anyone have any experience with this that could give me some advice, tips, etc?
Thanks! |
|||
06-10-20, 12:32 AM
Post: #2
|
|||
|
|||
RE: [TG11] Integrating new components with older ones
Hello dg1213,
We try pretty hard to be backwards-compatible. The radar won't be (analogue radar), and the GPS is probably not worth retaining (the built-in GPS in an Axiom will be much better) but the autopilot should be compatible through a low-cost Seatalk1 to SeatalkNG convertor. If you can tell me what other components you may have, I can confirm about those. To replace the radar you can use a Quantum or Quantum Doppler radar scanner. This can communicate wirelessly with the display so that you can re-use the existing cable for power (cut and splice with the new radar's cable) to simplify the installation. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)