Raymarine forum / Raymarine Forums / Instruments v / Is is possible to calibrate an instrument transducer via an a/c/e/eS/gS-Series MFD?

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is is possible to calibrate an instrument transducer via an a/c/e/eS/gS-Series MFD?
03-07-16, 05:39 PM (This post was last modified: 01-12-17 10:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
Is is possible to calibrate an instrument transducer via an a/c/e/eS/gS-Series MFD?
Is is possible to calibrate an instrument transducer via an a/c/e/eS/gS-Series MFD?

It is not possible for an a/c/e/eS/gS Series MFD (or earlier MFD designs) to calibrate transducers which have been interfaced to an iTC-5, ST70/ST290 instrument pod, or instrument display. Instrument transducers which have been interfaced to an iTC-5 or ST70/290 instrument pod must be calibrated via an i70/i70S MFID, ST70 MFID, or ST70+ Display. Instrument transducers which have been directly interfaced to the instrument transducer terminals of a Raymarine instrument display (ex. i40, i50, i60, ST60+, etc.) must be calibrated via the user interface of the Raymarine instrument display which the transducer has been directly interfaced to.

RAYFAQ#
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication