Raymarine forum / Raymarine Forums / Autopilots v / ACU 200 AWG Suggestion

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACU 200 AWG Suggestion
12-05-16, 02:48 PM
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 8
Joined: Nov 2016
Reputation: 0
ACU 200 AWG Suggestion
Considering the AWG size for a cable run length under 25 feet from the circuit panel to power the ACU 200; The ACU -will not- be powering the STng backbone; The ACU will power a Type-1 rotary drive.... what AWG is suggested for this run?
Find all posts by this user
Quote this message in a reply
12-13-16, 02:10 PM (This post was last modified: 12-13-16 02:11 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ACU 200 AWG Suggestion
Welcome to the Raymarine Forum mlpayne9367,

Drive type, voltage system (12V or 24V), and round trip distance to the batteries terminals (not the electrical panel) are the factors in determining the recommended wire gauge. The Power and drive cable selection table found on page 25 of the Evolution EV-1, ACU-100, ACU-200, ACU-300, ACU-400 Installation Instructions specifies the recommended wire gauge for each of these variables.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication