European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
|
Wiring help with installation
|
|
03-20-17, 01:28 PM
(This post was last modified: 03-20-17 03:51 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
|
Wiring help with installation
Chuck;
I have attached a wiring schematic of how I installed my new Raymarine products, could you review and let me know if it is properly wired. I have power to both units, but the i50 is not picking up a depth signal from the transducer. John Sharkey |
|||
|
|
03-20-17, 03:47 PM
(This post was last modified: 03-20-17 03:49 PM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
|
RE: Wiring help with installation
Welcome to the Raymarine Forum John,
Your diagram is correct as long as the total spur length is less than or equal to 6m. In order for an i50 Depth/Tridata Instrument to repeat Depth and/or Speed (Temp) data, the instrument must be configured as a Depth Repeater or Speed Repeater respectively. Instructions for configuring the Master / Repeater state may be found within section 6.4 Data master of the i50 Instruments Installation and Operation Instructions. |
|||
|
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)