The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] Setting depth offset

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Setting depth offset
12-12-17, 02:00 PM (This post was last modified: 12-12-17 02:23 PM by Chuck - Raymarine - Moderator.)
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 10
Joined: May 2016
Reputation: 0
[CA] Setting depth offset
Previously I had an ST-40 instrument and C70 MFD. I would set the offset for depth in the ST-40.

I did not upgrade the depth sensor, but did upgrade to an eS98 MFD with the depth, speed, and wind data connected to the system via an ITC-5. I have a P70 in this system as well.

Is there a way to set the offset of the transducer depth in the eS98 software? I have not found so far . . . perhaps there will be an option in the new Lighthouse software?

I still have the ST-40 and tried to connect it using the ST1 to STNG adapter. It powers the ST-40, but no data is shown. Perhaps there is a way to connect this to the system so to set offset.

Thanks in advance,
Robert
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Setting depth offset - [email protected] - 12-12-17 02:00 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication