The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Lighthouse 3.4.66 and Penta Easy Connect only port engine is displayed

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Lighthouse 3.4.66 and Penta Easy Connect only port engine is displayed
06-07-18, 02:28 PM (This post was last modified: 06-08-18 02:44 PM by Chuck - Raymarine - Moderator.)
Post: #1
Mikael Offline
Junior Member
**
 		Posts: 2
Joined: May 2018
Reputation: 0
[CA11] Lighthouse 3.4.66 and Penta Easy Connect only port engine is displayed
Just installed the new Volvo Penta "Easy Connect" engine NMEA 2000 interface to the Seatalk NG network and ES127 MFD.
According to the device itself, I have EVC connection to the NMEA 2000 bus. Signals are present on the bus as all the Volvo Penta instruments / gauges work perfectly for both engines, and these are connected to the same EVC bus.

But my ES127 with Lighthouse 3.4.66 only shows data from Port Engine.

What is also strange is that if I try to configure the engines in the settings menu of the MFD, I get error messages saying that no engine data is received for any of my two engines (Volvo Penta D4-300 with EVC-C)

Is there a known issue with this feature and Lighthouse 3.4.66?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Lighthouse 3.4.66 and Penta Easy Connect only port engine is displayed - Mikael - 06-07-18 02:28 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication