[CA] [CA11] Upgrading from SL70 to ev200 and E127’s

[markdd3880]

Hi Chuck
2)Apologies I did not realize the P70 indicated rudder angle so that would make the St60 redundant as you point out. Therefore I just wire the existing transducer to the actuator and thats basically it correct?
3) The depth transducer was indeed directly plugged into the L760 so the adapter is on the shopping list thank you for resolving this.

I also need to thank you for pointing me at Fox Marines engine data solution.... just ordering up a couple of units right now its a far better solution than the mercury gateway.

I am sure I know the answer to this with you being so involved on the internet but just checking you are aware of the AGLCA membership and website with regards to doing the Great Loop.
Very best
Mark