[CA11] Calibration question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Calibration question

09-06-18, 02:59 PM (This post was last modified: 09-12-18 02:39 PM by Chuck - Raymarine - Moderator.)

Post: #1

JeffTaylor Offline

Junior Member

Posts: 5
Joined: Jul 2016
Reputation: 0

[CA11] Calibration question

I have an X30 autopilot with ST7000+ control head. When I power it up, it beeps and says "calibration required." I went through the calibration routine, turning circles etc., and all seemed good. Shut the system down, came back the next day and it says "calibration required" again. The thing is, the calibration values I set on the previous day are still there, I can tell because the compass offset it correct when it wasn't before. What am I missing?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Calibration question - JeffTaylor - 09-06-18 02:59 PM

RE: [CA11] Calibration question - Chuck - Raymarine - Moderator - 09-12-18, 02:55 PM

User(s) browsing this thread: 1 Guest(s)