[TG11] RV300 - placement

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] RV300 - placement

09-23-18, 10:01 PM

Post: #2

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] RV300 - placement

Hello Watsala,

This isn't something we'd generally recommend, but from an acoustic point of view I don't think it will cause a problem. You will need to make sure that the outboard edge of the transducer is supported outside the hull, and that the nut/locking ring is also supported inside so that the surfaces that the transducer and locking ring clamp are parallel. I am assuming that this is what you plan, it's just not on shown on your drawing.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] RV300 - placement - watsala - 08-07-18, 04:38 AM

RE: [TG11] RV300 - placement - Tom - Raymarine - Moderator - 09-23-18 10:01 PM

User(s) browsing this thread: 1 Guest(s)