[CA] [CA11] Dual transducer placement

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Capecodfisherman,

Please note that it would be recommended that the B60 transducer be left in place as an additional fishfinder transducer to support 50kHz/200kHz fishfinder imaging, operation at depths not supported by the RV transducer, and to support bottom tracking at higher planing speeds than may be supported by the RV transducers. Should the B60 transducer's cable have been directly mated to a DSM30/DSM300/CP300/CP370 fishfinder sounder module, then it may be adapted to be mated to the 1kW Transducer socket of the Axiom Pro RVX MFD.

Should you opt to not follow this recommendation then it would have been recommended that the RV transducers be installed at the same distance from the transom and on opposite sides of the keel. However, the slight fore/aft offset of the RV transducers which you have described should have little, if any, impact upon the imaging produced by the system.