Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Tacktick instrument refusing to network
02-14-19, 12:51 AM
Post: #2
RE: [TG11] Tacktick instrument refusing to network
Hello brianm, sorry that you've not had a reply before.

That looks like the battery in the problem instrument has reached the end of its life. It sounds like it's had many years of service, and like any battery will gradually lose capacity over time and use. Over the break I'd say its residual charge has dropped below the level required for it to start back up again.

The batteries in most Tacktick products are replaceable. You'll find a cover on the back, secured with 4 Torx-head screws, and behind that will be either a 2-cell (as in the case of your mn100) or 3-cell (as in the case of some larger displays) battery pack. The replacement pack can be ordered from any Raymarine dealer under part TA118 (2-cell) or TA119 (3-cell), and comes with a Torx driver to open the cover, and a replacement seal.

In the meantime, you might be able to get the display running again temporarily by leaving it in bright sun to charge for several days. If the battery still has a little life.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Tacktick instrument refusing to network - Tom - Raymarine - Moderator - 02-14-19 12:51 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)