Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom 9 RV Sounder issues
03-05-19, 03:55 PM (This post was last modified: 03-06-19 10:32 AM by Chuck - Raymarine - Moderator.)
Post: #15
RE: [CA11] Axiom 9 RV Sounder issues
Raymarine vs. customer config follows:

The issue would occur in chart/sonar mode or sonar only mode. All other settings were on auto. There are no other MFD's in my set up. My system does have a RS150 GPS antenna which has been selected as the system's GPS data source.

Raymariner: Axiom 9 RV with TH split 12 degree bronze 'ducers. Bench 5; Cust: system utilized an RV-100 transducer.
Raymariner: NO STNG connection; Cust: STng with only RS 150 connected
Raymariner: S/W at 3.8.97; Cust: Same
Raymariner: Internal GPS on, but no GPS Fix; Cust: External RS 150 connected, GPS FIX
Raymariner: Factory Reset unit after downgrade to 3.8.97; Cust: Same
Raymariner: English (US); Cust: Same
Raymariner: Fishing (fresh water); Cust: Same
Raymariner: Boat details left to default; Cust: changed these to suit his boat
Raymariner: Navionics card in uSD card slot at the back; Cust: Same
Raymariner: Split Chart/Sonar app; Cust: Same
Raymariner: Surface filter set to 0 manual; Cust: Auto
Raymariner: Interference Rejection to high; Cust: Auto
Raymariner: 2nd Echo interference Rejection set to high: Cust: Low
Raymariner: Range set to auto; Cust: Same
Raymariner: Depth source auto; Cust: Same
Raymariner: Bottom fill on; Cust: Off
Raymariner: No other MFD's or transducers connected; Cust: Same
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom 9 RV Sounder issues - ktcarter - 03-05-19 03:55 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)