[LW] [LW11] Itc-5 not working

[spycatcher]

Hi Louise, thank you for the reply. I have attached a schematic of my system

the indicator lights on the itc-5 are as follows:

depth, constant green
speed/temp, fast intermittent. green
wind, slow intermittent. green

i am running the latest software and the depth transducer is in the water

I had the whole system running fine when i laid it out on my living room floor about a month ago. it is now installed on my boat.
i found a thread on wind voltages and the readings on the wind instrument are within the parameters
the a75 mfd occasionally has bouts of constantly rebooting itself and it is getting a constant 13.0 volts

when i goto set-up/system settings/data sources/wind. i get the following error message:

the following devices are preventing data source selection
ISO(55 d5 7c e7 00 8c 8c c0) CAN (43)

i occasionally get the same error message with depth

the wheel pilot appears to work fine on track mode
the log/temp appears to work fine
the depth can be erratic at times ie. it will show a depth of 8 feet when i am in 300 odd feet of water

i have tried taking the i70s of the network and running it as a stand alone and the wind is still the same, not working

i have run the mfd as a stand alone of the network and it still has bouts of constantly rebooting itself and occasionally freezes completely and i have to switch it off at the panel to reboot it. i have a navionics card in it and thought that might be the problem, so ran it without the card and the problems are still the same

i will have to go and sweep the cabin sole now as there are tufts of my hair all over it.

cheers

Rob